nobcha23のエアバンド受信機自作ブログ DIY airband receiver BLOG

エアバンドレシーバーキットの組み立て、改造を手掛けます Assemble and remodel Chinese airband receiver kit

ATS-miniでエアバンドを聞いてみる Watching the air band communication with ATX-mini

YOUTUBEなどで話題のATS-miniを買ってみました。以前、ATS20でエアバンドを聞こうと思って、クリコン(クリスタルコンバータ)を作ったのがありましたので、つないでみました。 I bought the ATS-mini, which has been a hot topic on YouTube etc. I had previously made a crystal converter to listen to air bands with the ATS20, so I connected it.

 

ATS-20キットを中国製エアバンドレシーバーキットにつないでみた  Connect ATS-20 kit with Chinese airband receiver kit  (ATS-20基板キットを買いました その3 I bought ATS-20 kit. part 3)   

nobcha23.hatenadiary.com

 

ATS-20+で付加されている100MHzあるいは110MHzのコンバータと同じようなものです。

It is similar to the 100MHz or 110MHz converter that is added to the ATS-20+.

ちょっと感度がいまいちですが、伊丹空港のATISとかタワーとかを無事受信できました。ATS-20,ATS25と同じPU2CLRのソフトウェアなので、18MHzから30MHzまで受信周波数設定が大変です。周波数メモリー32chがあるので、エアバンドモニターをするのなら、ここに設定を入れておく必要があるようです。

Although the sensitivity is a little low, I was able to successfully receive ATIS and tower signals at Itami Airport. Since it uses the same PU2CLR software as the ATS-20 and ATS25, it's difficult to set the receiving frequency from 18MHz to 30MHz. It has 32 frequency memory channels, so if you want to monitor airbands, you'll need to enter the settings here.
 
 

さて、受信感度ですが、クリコンの性能がいまいちで、-90dBm@128.6MHzでした。また、R909-SINADインディケータもまだ調整がいまいちなので、SINAD値も信用できるのか検討中です。

As for the receiver sensitivity, the crystal converter's performance was not so good, and it was -90dBm@128.6MHz. Also, the R909-SINAD indicator is still not adjusted properly, so I'm considering whether the SINAD value is reliable.


感度測定機器配線写真

クリコン+ATS-miniの感度をはかる



回路図

エアバンド用クリコン

 

 

回路図の通り、クリコンの構成は2SK439+NE612Aです。フィルターとミキサーでの損失はRFアンプとIFアンプで補えると期待してました。ATS-miniの親機としての感度(

www.jh1lhv.tokyo

)より上を行くと思ってました。SA612AはHF-VHFで14dBも変換利得があるんですからね。こちらもこの際利得配分を検討してみようかと思っております。

 

As shown in the circuit diagram, the crystal converter configuration is a 2SK439 + NE612A. I was hoping that the RF and IF amplifiers would compensate for the losses in the filters and mixer. I thought the sensitivity would be better than the ATS-mini's parent unit ( https://www.jh1lhv.tokyo ). The SA612A has a conversion gain of 14 dB from HF to VHF. I'm also thinking about revising the gain distribution here.